Pan's Sling Wax is specifically designed with the extreme demands of slinging in mind. Made with a blend of waxes, including two types of beeswax, it does not contain paraffin. It is more flexible, and less likely to flake than paraffin-based fabric waxes.
See waxing instructions below.
Use Pan's Sling Wax on your cordage, leather edging, and finger loop.
Waxing your sling offers several advantages, including:
If you choose to wax the entire sling it can be limited to step 1 below, giving the sling more body. Or you can give the entire cordage an outer layer of wax by following steps 1 and 2 below. Step 1 focuses on adding body to the sling while step 2 is more about outer abrasion. Keep in mind that step 2 will give the sling a slight tack feel.
However, it is essential to wax the last 2 inches of the release cord with both steps 1 and 2 and follow up with rubbing on additional wax before each slinging session.
Pan's Sling Wax can be used on other waxable fabrics as well. Follow manufacturer recommendations. You will skip step 2 in the waxing instructions when applying to other fabrics.
To apply wax to your sling cordage, work in 6-12" manageable sections. Apply the wax in 3-6 smooth strokes along the cord, making sure to coat the entire circumference of the cord evenly. Then, use a hair dryer to melt the wax into the cord. Do not use a heat gun, it will melt and ruin the cord. Repeat this process 1-3 more times, until the wax no longer easily absorbs into the cord. This will add density to the cordage and create a foundation for the final coat of wax.
To finish, apply a thin coat of wax to the surface of the cord by pulling it through your fingers. Avoid using direct heat for this final coat. The goal is to have a thin, protective layer of wax on the surface. You can always reheat the cord with a hairdryer and wipe off any excess wax if needed.
Before each slinging session, re-apply wax to the last few inches of the release cord, just before the leather release tab. This can be done easily in the field.
Follow-up waxing
To remove dirty wax or apply more wax to worn-off sections:
With a block of Pan's Performance Wax, you can quickly rub wax on worn-off areas, whether you are at home or in the field.
Removing wax
To remove wax, heat it with a hairdryer and wipe it down with a paper towel. Do not use a heat gun, it will melt and ruin the cord.
Note: Once you add wax to the sling, it will permanently darken the sling, even if you remove the wax from the surface of the cord. It is not possible to completely remove wax from the inner fibers of the cord.
